Installing the headlining (with panorama glass roof)

Precondition 

Shift the front seat surfaces as far down and towards the rear as possible. Shift the front backrests as far back as possible.

• Position the headlining (1) correctly in the vehicle with a support person.
• Feed in the headlining (1) on the relative edge protection.
• Clip in the headlining (1) using the clips (2).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Secure the headlining (1) to the clips (2).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Position the trim (1) and clip in with the clips (2).

Courtesy of BMW OF NORTH AMERICA, INC.

• Equipment specification with rear air conditioning/vanity mirror at the rear: 

  Tighten screws (1) left and right.

  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Headlining
  	tightening torque	1.4 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Insert the wiring harness (4) and secure to the associated cable clips.
• Connect connectors (1), (2) and (3).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Secure the headlining to the clips (2).
• Tighten down screw (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING THE INTERIOR REARVIEW MIRROR .
• Refer to INSTALLING THE COVERS FOR THE INTERIOR REARVIEW MIRROR .
• Refer to INSTALLING THE VANITY MIRROR LIGHT AT THE FRONT LEFT OR RIGHT .
• Refer to INSTALLING THE RIGHT HANDS-FREE MICROPHONE .
• Refer to INSTALLING ROOF FUNCTION CENTER (FZD) .
• Refer to INSTALLING BOTH SUN VISORS AND COUNTER SUPPORTS .
• Refer to INSTALLING A-PILLAR TRIM PANEL .
• Refer to INSTALLING THE UPPER B-PILLAR TRIM PANEL .
• Refer to INSTALLING C-PILLAR TRIM PANEL .
• Refer to INSTALLING THE HOLDER ON LEFT OR RIGHT .
• Refer to INSTALLING BOTH REAR VANITY MIRRORS .
• Refer to INSTALLING BOTH FRESH AIR GRILLES IN THE HEADLINING .
• Refer to INSTALLING REAR INTERIOR ROOF LIGHT .