Install brake light switch

• Clip the holder for the brake light switch (3) into the brake pedal.
• Press brake pedal.
• Push the brake light switch (2) in the opposite direction to the arrow into the holder for the brake light switch (3) up to the stop.
• Counter support the holder for the brake light switch (3) and move back the brake pedal slowly to the initial position at the same time.
• Slowly pull brake pedal back to stop.
• Connect connector (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING THE TRIM PANEL FOR THE PEDAL ASSEMBLY .