Installing the left-hand charge air cooler

• Feed in charge air cooler (1)  to the guide (2)  and into the throttle body.
• Lock the lock (3)  audibly.
• Tighten down screw (4)  .

Courtesy of BMW OF NORTH AMERICA, INC.

• Connect coolant line (1)  to the charge air cooler and lock it audibly.
• Connect coolant line (2)  to the charge air cooler and lock it audibly.
• Attach coolant line (3)  to the charge air cooler.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Attach plug connection (1)  to the charge air cooler.
• Attach tank vent valve (2)  to the charge air cooler.
• Connect connector (3)  to the pressure sensor on the charge air cooler and lock audibly.

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING THE LEFT UNFILTERED-AIR DUCT .
• Refer to CONNECTING THE LEFT CHARGE AIR LINE TO THE EXHAUST TURBOCHARGER .
• Refer to INSTALLING INTAKE FILTER HOUSING .
• Refer to INSTALLING ACOUSTIC COVER .
• Refer to CONNECTING THE COOLANT HOSE TO THE AUXILIARY COOLANT PUMP .
• Refer to INSTALLING FAN COWL .
• Refer to INSTALLING THE FRONT UNDERBODY PROTECTION OR FRONT THRUST FIELD .
• Refer to INSTALLING THE UNDERBODY PROTECTION OF THE STEERING GEAR OR THE FRONT THRUST FIELD .
• Refer to INSTALLING THE REAR TOP CROSS CONNECTION .
• Refer to INSTALLING FRONT CROSS CONNECTION (FRONT-END STRUT REMOVED) .
• Refer to INSTALLING BOTH FRONT-END STRUTS .
• Refer to INSTALLING THE COVER OF THE ENGINE COMPARTMENT CENTER .
• Refer to FILLING THE LOW-TEMPERATURE COOLING SYSTEM WITH THE VACUUM FILLING EQUIPMENT .
• Refer to VENTING THE LOW-TEMPERATURE COOLING SYSTEM .