Install the DSC control unit
NOTE:
TECHNICAL INFORMATION
Maintain conditions of absolute cleanliness.
Maintain conditions of absolute cleanliness.
- Carefully attach the DSC control unit (5) to the hydraulic unit.
- Replace screws (1) to (4).
Parts: Screws
- Tighten the screws (1) to (4) step by step in this sequence.
TIGHTENING TORQUE SPECIFICATIONS
| DSC control unit on hydraulic unit | ||
|---|---|---|
| Screw Replace screws. |
Screw in screws and evenly tighten crosswise. 1. tightening torque |
1.5 Nm |
| 2. tightening torque | 2.5 Nm | |
| Position the 3rd tightening torque | 3.5 Nm | |
Follow-up work
- Refer to INSTALLING HYDRAULIC UNIT .
- Refer to INSTALLING THE UNDERSHIELD ON THE SIDES .
- Refer to INSTALLING THE REAR SECTION OF THE FRONT WHEEL ARCH COVER .
- Refer to CLEANING THE CONTACT SURFACES BETWEEN THE BRAKE DISC AND THE WHEEL RIM .
- Refer to ATTACHING THE FRONT LEFT WHEEL .
- Refer to REMOVING THE BRAKE PEDAL TENSIONER .
- Refer to CONNECTING THE BLEEDER UNIT FOR THE BRAKE FLUID .
- Refer to FLUSH AND VENTING THE REAR AXLE BRAKE CIRCUIT .
- Refer to FLUSH AND BLEEDING THE FRONT AXLE BRAKE CIRCUIT (HIGH BRAKE) .
- Refer to DISCONNECTING THE BLEEDER UNIT FOR THE BRAKE FLUID .
- Refer to DSC UNIT START-UP/DRIVING DYNAMICS SENSOR ADJUSTMENT/CONTROL UNIT PROGRAMMING .