Installing rear brake hose

• Fit and tighten brake hose (2) on brake caliper.
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Brake hose to brake caliper, rear
  	tightening torque	24 Nm

• Hook the brake hose into holder (1).

  Courtesy of BMW OF NORTH AMERICA, INC.

  NOTE: RISK OF DAMAGE 
  Incorrect routing of the brake hose. 
  If the brake hose is twisted or in contact with surrounding components, it can be damaged and cause the brake system to fail. 

  • Do not install the brake hose in a twisted position.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Insert the brake hose (1) in the holder on the body side.
• Ensure a correct fit of the retaining spring (2)!
• Attach and tighten the union screw (3).

Follow-up work 

• Refer to INSTALLING REAR LEFT OR RIGHT WHEEL .
• Refer to REMOVING THE BRAKE PEDAL TENSIONER .
• Refer to CONNECTING THE BLEEDER UNIT FOR THE BRAKE FLUID .
• Refer to FLUSH AND VENTING THE REAR AXLE BRAKE CIRCUIT .
• Refer to DISCONNECTING THE BLEEDER UNIT FOR THE BRAKE FLUID .