Install brake caliper in the rear
- Fit and tighten brake hose (2)
on brake caliper.TIGHTENING TORQUE SPECIFICATIONS
Brake hose to brake caliper, rear tightening torque 24 Nm - Hook the brake hose into the holder (1)
.NOTE: RISK OF DAMAGE
Incorrect routing of the brake hose. If the brake hose is twisted or in contact with surrounding components, it can be damaged and cause the brake system to fail.- Do not install the brake hose in a twisted position.
- Insert the brake hose (1) into the body side holder.
- Make sure the retaining spring (2) fits correctly!
- Attach and tighten the union screw (3) .
TIGHTENING TORQUE SPECIFICATIONS
| Brake pipe screw connection/Union screws | ||
|---|---|---|
| tightening torque | 17 Nm | |
Follow-up work
- Refer to REMOVING THE BRAKE PEDAL TENSIONER .
- Refer to GREASE BRAKE PADS, BRAKE ANCHOR PLATE AND BRAKE CALIPER WITH BRAKE PAD PASTE .
- Refer to INSTALLING REAR BRAKE PADS .
- Refer to INSTALLING THE REAR BRAKE PAD WEAR SENSOR .
- Refer to INSTALLING REAR LEFT OR RIGHT WHEEL .
- Refer to CONNECTING THE BLEEDER UNIT FOR THE BRAKE FLUID .
- Refer to FLUSH AND VENTING THE REAR AXLE BRAKE CIRCUIT .
- Refer to DISCONNECTING THE BLEEDER UNIT FOR THE BRAKE FLUID .
- Refer to START-UP OR BEDDING IN BREAK-IN OF NEW BRAKE PADS AND ROTORS (REAR BRAKE) .