Installing engine wiring harness section/DME

Overview graphic of the wiring harness section for the engine/DME 

Courtesy of BMW OF NORTH AMERICA, INC.

• Feed in and position the vehicle wiring harness (3)  .
• Position the eyelet (4)  .
• Tighten down screw (2)  .

• Fix wiring harness fasteners (1)  .

  Courtesy of BMW OF NORTH AMERICA, INC.

• Clip in the wiring harness (2)  in area of holder (1)  .

  Courtesy of BMW OF NORTH AMERICA, INC.

• Position the eyelet (3)  .
• Tighten nut (2)  .

Courtesy of BMW OF NORTH AMERICA, INC.

• Fasten the clip (1)  .
• Fix wiring harness fasteners (2)  .
• Connect and lock the plug connections (1)  .

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING ALTERNATOR .
• Refer to CONNECTING THE COOLANT LINES OF THE TURBOCHARGER .
• Refer to INSTALLING CLEAN AIR PIPE OF CYLINDER BANK 1 .
• Refer to INSTALLING THE CLEAN AIR PIPE OF CYLINDER BANK 2 .
• Refer to ATTACHING THE CHARGE AIR COOLER .
• Refer to CONNECTING THE LEFT CHARGE AIR LINE TO THE TURBOCHARGER .
• Refer to CONNECTING THE RIGHT CHARGE AIR LINE TO THE TURBOCHARGER .
• Refer to INSTALLING THE UNDERBODY PROTECTION OF THE STEERING GEAR OR THE FRONT THRUST FIELD .
• Refer to INSTALLING THE FRONT UNDERBODY PROTECTION OR FRONT THRUST FIELD .
• Refer to INSTALLING THE FRONT BOTTOM RIGHT WHEEL ARCH COVER .
• Refer to CLOSING THE HIGH-TEMPERATURE COOLANT CIRCUIT .
• Refer to INSTALLING DRIVE BELT .
• Refer to PARTIALLY FASTENING THE COOLANT EXPANSION TANK FOR THE LOW-TEMPERATURE COOLANT CIRCUIT .
• Refer to INSTALLING FAN COWL .
• Refer to INSTALLING THE REAR TOP CROSS CONNECTION .
• Refer to INSTALLING FRONT CROSS CONNECTION (FRONT-END STRUT REMOVED) .
• Refer to INSTALLING BOTH FRONT-END STRUTS .
• Refer to INSTALLING THE COVER OF THE ENGINE COMPARTMENT CENTER .
• Refer to CONNECTING ALL BATTERY GROUND LEADS .
• Refer to FILLING AND VENTING THE HIGH-TEMPERATURE COOLANT CIRCUIT .