Install tension strut on shock tower
NOTE:
TECHNICAL INFORMATION
Driving without the strut brace/front-end strut or tension strut is not permitted.
Driving without the strut brace/front-end strut or tension strut is not permitted.
- Version 1:
Install the tension strut (3) on the shock tower.
Tighten down screws (1).
TIGHTENING TORQUE SPECIFICATIONSTension strut on firewall M10x25 screw Tightening torque 56 Nm - Replace screws (2).
Parts: Screws
- Tighten down screws (2).
TIGHTENING TORQUE SPECIFICATIONSTension strut to shock tower screw
Replace screws.Joining torque 56 Nm Angle of rotation 90° - Version 2:
Install tension strut (3) on the shock tower.
Tighten down screw (1).
TIGHTENING TORQUE SPECIFICATIONS
| Tension strut on firewall | ||
| M10x25 screw | Tightening torque | 56 Nm |
- Replace the screw (2).
Parts: Screw
- Tighten down screw (2).
TIGHTENING TORQUE SPECIFICATIONS
| Tension strut to shock tower | ||
| screw Replace screws. |
Joining torque | 56 Nm |
| Angle of rotation | 90° | |
Repairing the thread on the strut tower
- Repair the damaged thread with the Helicoil thread insert.
Consumable
| Helicoil thread insert | M10x25 mm | 33 30 6 782 756 |
Follow-up work
- Refer to INSTALLING WINDSHIELD PANEL COVER .
- Refer to INSTALLING LEFT AND RIGHT WIPER ARM .
- Refer to INSTALLING THE REAR RIGHT ENGINE COMPARTMENT COVER .
- Refer to INSTALLING THE COVER OF THE ENGINE COMPARTMENT ON THE REAR LEFT .