Installing the bottom automatic air flap control

• For replacement: 

  In the equipment version with ACC sensor, the recesses must be transferred to the new part and cut out in a way similar to the used part.

• Connect the plug connection.
• Feed in the bottom automatic air flap control (2)  .
• Tighten down screws (1)  .

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING THE HOLDER FOR THE ACC SENSOR .
• Refer to INSTALLING BUMPER COVER, FRONT .
• Refer to INSTALLING FRONT ORNAMENTAL GRILLE .
• Refer to INSTALLING THE COVER OF THE ENGINE COMPARTMENT CENTER  .
• Refer to INSTALLING FRONT SECTION OF THE FRONT WHEEL ARCH COVER (PARTIALLY REMOVED) .
• Refer to ADJUSTING THE ACC SENSOR .