Install the front top cross connection
- Attach the front top cross connection (4).
- Tighten down screws (3).
TIGHTENING TORQUE SPECIFICATIONS
| Front reinforcement strut | ||
| screw Replace screws. |
Tightening torque | 19 Nm |
- Tighten the screws (1).
- Tighten down screws (2).
TIGHTENING TORQUE SPECIFICATIONS
| Front Y-strut to cross connection and/or bumper bracket | ||
| M6x20 screw | Tightening toque | 11.8 Nm |
- Mount the expanding rivets (1).
Follow-up work
- Refer to INSERTING TOP AUTOMATIC AIR FLAP CONTROL .
- Refer to INSTALLING BUMPER COVER, FRONT .
- Refer to INSTALLING FRONT SECTION OF THE FRONT WHEEL ARCH COVER (PARTIALLY REMOVED) .
- Refer to INSTALLING FRONT ORNAMENTAL GRILLE .
- Refer to INSTALLING FRONT CROSS CONNECTION (FRONT-END STRUT REMOVED) .
- Refer to INSTALLING BOTH FRONT-END STRUTS .
- Refer to INSTALLING THE COVER OF THE ENGINE COMPARTMENT CENTER .