Installing the storage shelf (with roller sunblind)

• If applicable, connect the plug connections.
• Insert the storage shelf with the roller sunblind (3) towards the rear.
• Connect the plug connection (1).
  NOTE: Perform the steps on the right and left side.
• Tighten down screw (2).

  Courtesy of BMW OF NORTH AMERICA, INC.

  TIGHTENING TORQUES SPECIFICATION
  
  

  Roller sunblind
  Tightening torque		8 Nm

• Install the rear shelf (3) and while doing so, feed in the seat belt.
• Mount the expanding rivets (2).
• Tighten nuts (1).
  TIGHTENING TORQUES SPECIFICATION
  
  

  Storage shelf
  Tightening torque		3 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Feed the trim (1) into the seat belt (2).
• Clip the trim (1) into the rear shelf.

  Courtesy of BMW OF NORTH AMERICA, INC.

  NOTE: TECHNICAL INFORMATION 
  Component is encoded against incorrect assembly.
• Mount end fitting (2).
• Replace the screw (1).

  Parts:  Screw

• Tighten down screw (1).

TIGHTENING TORQUES SPECIFICATION

End lining to body
M10 Replace screw.	tightening torque	42 Nm

Courtesy of BMW OF NORTH AMERICA, INC.