Installing the LED module on the decorative strip at right
NOTE:
TECHNICAL INFORMATION
The LED module must be readdressed after replacement.
Addressing can only be carried out with the diagnosis system.
If a swap of LED modules was carried out as part of the troubleshooting, this swap should be reversed prior to automatic addressing.
The LED module must be readdressed after replacement.
Addressing can only be carried out with the diagnosis system.
If a swap of LED modules was carried out as part of the troubleshooting, this swap should be reversed prior to automatic addressing.
NOTE:
The description is provided only at one component. The procedure is the same for all other components.
- Clip LED module (2) into fiber-optic conductor.
- Clip the LED module (2) into the holder.
- Clip the fiber-optic conductor into the holder.
- Connect connector (1) to LED module (2).
Addressing the LED module
NOTE:
TECHNICAL INFORMATION
The LED module must be readdressed after replacement.
Addressing can only be carried out with the diagnosis system.
If a swap of LED modules was carried out as part of the troubleshooting, this swap should be reversed prior to automatic addressing.
The LED module must be readdressed after replacement.
Addressing can only be carried out with the diagnosis system.
If a swap of LED modules was carried out as part of the troubleshooting, this swap should be reversed prior to automatic addressing.
- Execute the service function via the following path:
- Body
- Lighting
- Interior light automatic addressing