Install the seat belt finisher strip

• Install the seat belt finisher strip (1)  and in this process, insert the end fitting.
• Insert the seat belt finisher strip (1)  at the rear into the guides (3)  .
• Clip in the seat belt finisher strip (1)  in the clips (2)  .
• Make sure that seat belt finisher strip (1)  is correctly fitted against the edge protection.

  Courtesy of BMW OF NORTH AMERICA, INC.

  NOTE: TECHNICAL INFORMATION 
  Component is encoded against incorrect assembly.
• Mount end fitting (2)  .
• Replace the screw (1)  .

  Parts:  Screw

• Tighten down screw (1)  .

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING C-PILLAR TRIM PANEL .
• Refer to REMOVING REAR SEAT BACKREST .
• Refer to INSTALLING THE REAR SEAT .