Installing the rear bumper cover

• Connect the plug connections and install bumper cover (2).
• Snap the bumper cover (2) into the locks (3) at the top.
• Snap the bumper cover (2) into the remaining locks on the side and at the bottom.
• Tighten down screws (1).

  Courtesy of BMW OF NORTH AMERICA, INC.

  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Bumper cover to guide, middle
  	Tightening torque	2.7 Nm

• Tighten down screws (1).
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Bumper cover to side guide
  Screw	Tightening torque	3 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Only for G30/G38: 

Tighten screws (arrows).

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING BOTH TRIM PIECES FOR THE EXHAUST TAILPIPE .
• Refer to INSTALLING THE TRIM ON THE REAR BUMPER PANEL .
• Refer to INSTALLING BOTH TAIL LIGHTS ON THE SIDE PANEL .
• Refer to INSTALLING THE LUGGAGE COMPARTMENT WHEEL ARCH TRIM PANEL ON THE RIGHT .
• Refer to INSTALLING LUGGAGE COMPARTMENT WHEEL ARCH TRIM PANEL, LEFT .
• Refer to INSTALLING LOADING EDGE TRIM .
• Refer to ON VERSION WITH COMPACT SPARE WHEEL: INSTALLING THE STORAGE TRAYS .
• Refer to INSTALLING THE LUGGAGE COMPARTMENT FLOOR COVERING .