1236 ELECTRIC POWERTRAIN CONTROL SYSTEM (740e xDrive PHEV 2017-2019, 745e xDrive PHEV 2020-2022)
1236 TIGHTENING TORQUE OVERVIEW
| Battery ground lead to electrical machine electronics | ||
| M8x16 Observe notes in repair information on earth bonding screw connections. |
Tightening torque | 19 Nm |
| Busbar to housing | ||
| M5 Replace screw. |
Tightening torque | 4.5 Nm |
| Clamp of excitation cable to housing | ||
| M5 Replace screw. |
Tightening torque | 4 Nm |
| Clamp of excitation cable to threaded bolt | ||
| M5 | Tightening torque | 3.9 Nm |
| Coolant line to electrical machine electronics | ||
| M6x30 | Tightening torque | 8 Nm |
| Double threaded bolt to housing | ||
| M5 Replace nut. |
Tightening torque | 4.5 Nm |
| Electrical machine electronics busbar to aggregate connection | ||
| M5 Replace screw. |
Tightening torque | 4.5 Nm |
| Electrical machine electronics to housing | ||
| M6 Replace screw. |
Tightening torque | 8 Nm |
| Angle of rotation | 90° | |
| EME busbar at high-voltage connection | ||
| M5 Replace screw. |
Tightening torque | 4.5 Nm |
| Excitation cable to electrical machine electronics | ||
| M5 | Tightening torque | 3.9 Nm |
| High-voltage cable to electrical machine electronics | ||
| M6x25 | Tighten screws in crosswise sequence. | |
| Joining torque | 3 Nm | |
| Tightening torque | 8 Nm | |
| High-voltage connector to electric drive unit | ||
| M8x46 | Tightening torque | 19 Nm |
| Holder for electrical machine electronics (ELE) to electrical machine electronics (ELE) | ||
| M6x30 Replace screws. |
Joining torque | 8 Nm |
| Angle of rotation | 90° | |
| Holder for electrical machine electronics to body | ||
| M8x20 Replace screws. |
Tightening torque | 28 Nm |
| Angle of rotation | 90° | |
| Holder for electrical machine electronics to units compartment | ||
| M6x16 Replace screws. |
Tightening torque | 12 Nm |
| Angle of rotation | 90° | |
| Holder for tension relief | ||
| M6 | Tightening torque | 8 Nm |
| Holder for tension relief to electrical machine electronics | ||
| M6 Replace screws. |
Joining torque | 4 Nm |
| Angle of rotation | 45° | |
| Positive battery cable to electrical machine electronics | ||
| M8x16 | Tightening torque | 15 Nm |
| Potential equalization line to electrical machine electronics | ||
| M8x16 Observe notes in repair information on earth bonding screw connections. |
Tightening torque | 19 Nm |
| Shield plate to housing | ||
| M5 Replace screw. |
Tightening torque | 4.5 Nm |
| Y-cable at housing | ||
| M5 Replace screw. |
Tightening torque | 4.5 Nm |