Installing the upper B-pillar trim panel

NOTE: Description is for left component only. Procedure on the right side is identical.

• Attach the B-pillar trim panel (1) and guide in the safety belt.
• Feed in the B-pillar trim panel (1) at the top on the headliner and clip into the clips (2).
• Check the front and rear of the B-pillar trim panel (1) for the correct fit at the edge protection.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Adjust the front seat completely to the front and top.
• Insert the end fitting (2).
• Replace the screw (1).

  Parts:  Screw

• Tighten down screw (1).

Courtesy of BMW OF NORTH AMERICA, INC.

TIGHTENING TORQUE SPECIFICATIONS

Seat belt strap fitting to seat mechanism
M10 Replace screw.	tightening torque	42 Nm