51 71... Removing and installing/replacing (front) left or right suspension cross-brace
WARNING: This page does not describe the selected car, but rather 50 other vehicles, including the 2016 BMW M5, 2016 BMW ActiveHybrid 5, 2016 BMW 550i xDrive, 2016 BMW 550i, and 2016 BMW 535i xDrive. However, it is still accessible from the selected car via links, so may be relevant.
Special tools required:
IMPORTANT:
Driving without the suspension cross-brace is not permitted. (risk of damage to the body).
Tighten screw on suspension cross-brace to torque. Then tighten to angle of rotation, special tool 00 9 120 .
Tighten screw on suspension cross-brace to torque. Then tighten to angle of rotation, special tool 00 9 120 .
Release screws (1).
Tightening torque 51 61 1AZ AND 2AZ .
Remove suspension cross-brace (2).
Installation:
Make sure suspension cross-brace (2) is in correct installation position. Screw with washer is fitted at connection, front top.