Replacing cross member for transmission mounting (4' Series Coupe/Convertible, 4' Series Gran Coupe Sedan)

Necessary preliminary tasks: 

• Remove rear UNDERBODY PROTECTION .
• Support transmission with lifter.

Removal: 

Loosen screws (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Loosen screw (1).

Remove transmission cross-member (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Install transmission cross member (2).

Insert screw (1) and tighten.

Tightening torque 22 32 6AZ .

Courtesy of BMW OF NORTH AMERICA, INC.

Insert screws (1) and tighten.

Tightening torque 22 32 3AZ .

Courtesy of BMW OF NORTH AMERICA, INC.

Required follow-up work: 

• Install the rear UNDERBODY PROTECTION .