Crank the engine twice (manual transmission)

• Release screws (5) from special tool 2 358 122  and remove the gauges (3) and (4).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Remove special tool 2 288 380  .

  Courtesy of BMW OF NORTH AMERICA, INC.

  NOTE: RISK OF DAMAGE 
  Damage to the engine  .
  If the engine is manually rotated in the wrong direction of rotation, the engine can be damaged  .

  • Only rotate the engine manually in the correct direction of rotation: a) clockwise when looking at the damper, or b) counterclockwise when looking at the chain drive. b) applies only if the timing chain is installed in the rear.
• Turn engine on the vibration damper with special tool 0 493 380 (11 6 480)  twice in direction of engine rotation.
• Perform the work steps "block crankshaft in the TDC firing position of the 1st cylinder"  and "Block the camshafts with the special tool"  as described before.

Courtesy of BMW OF NORTH AMERICA, INC.