Installing both actuators

• Check seal (1)  for damage and, if necessary, replace actuator (2)  .

  Courtesy of BMW OF NORTH AMERICA, INC.

  NOTE: The figure shows the rear of the engine.
• Position both actuators.
• Connect and lock both connectors (1).
• Make sure the connectors (1)  engage audibly.

  Courtesy of BMW OF NORTH AMERICA, INC.

  NOTE: The figure shows the rear of the engine.
• Position special tool 2 360 895  correctly on the actuator (1)  of the exhaust side.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Position the actuator (1)  of the exhaust side and turn in the arrow direction with the special tool 2 360 895  until the limit stops tap the clamps.

  Courtesy of BMW OF NORTH AMERICA, INC.

  NOTE: The figure shows the rear of the engine.
• Position special tool 2 360 895  correctly on the actuator (1)  of the intake side.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Position the actuator (1)  of the intake side and turn in the arrow direction with the special tool 2 360 895  until the limit stops tap the clamps.

  Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING THE PARTITION WALL ATTACHMENT PART .
• Refer to INSTALLING THE RIGHT ENGINE BULKHEAD .
• Refer to INSTALLING ACOUSTIC COVER AT REAR .
• Refer to INSTALLING THE SOUND INSULATION ON THE BULKHEAD UPPER PART CENTER .
• Refer to INSTALLING BOTH WIPER ARMS .
• Refer to ATTACHING COWL PANEL COVER .
• Refer to INSTALLING TENSION STRUT ON SPRING STRUT DOME .
• Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT ON THE RIGHT .
• Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT ON THE LEFT .
• Refer to INSTALLING ACOUSTIC COVER .