Install front engine encapsulation

• Install the engine encapsulation (1)  .

  Courtesy of BMW OF NORTH AMERICA, INC.

• Correctly route the wiring harness (3)  and clip it in at the highlighted areas.
• If necessary, position the ground cable and secure it with the screw.
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Front ground cable to cylinder head
  M6	tightening torque	8 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Connect connectors (1)  and (2)  .
  NOTE: TECHNICAL INFORMATION 
  Make sure that the connections are locked correctly. The locks must engage audibly.
• Connect the ventilation line (2)  with the intake plenum.
• Connect the ventilation line (1)  with the tank vent valve and clip it in at the highlighted area.

  Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up works 

• Refer to INSTALLING CLEANING AIR PIPE .
• Refer to INSTALLING INTAKE SILENCER HOUSING .
• Refer to INSTALLING ACOUSTIC COVER .