Installing the transmission oil cooler
- Install the transmission oil cooler (5) .
- Tighten down screw (4)
.TIGHTENING TORQUE SPECIFICATIONS
Transmission oil cooler on crankcase M6 8 Nm - Tighten the screws (3)
.TIGHTENING TORQUE SPECIFICATIONS
Transmission oil cooler on crankcase M6 8 Nm - Connect the transmission oil lines (1) and lock them audibly.
- Connect and audibly lock coolant line (2) .
- Connect the coolant line (1) and lock it audibly.
Follow-up work:
- Refer to INSTALLING THE INTAKE PLENUM
- Refer to INSTALLING THE HOLDER FOR THE DIGITAL MOTOR ELECTRONICS-CONTROL UNIT
- Refer to INSTALLING THE INTEGRATED POWER SUPPLY MODULE (PDM)
- Refer to INSTALLING THE DME CONTROL UNIT
- Refer to CONNECTING THE CONNECTOR WITH THE DME CONTROL UNIT AND THE POWER DISTRIBUTION BOX (PDM)
- Refer to INSTALLING ACOUSTIC COVER
- Refer to CONNECTING THE COOLANT HOSE TO THE RADIATOR OF THE LOW-TEMPERATURE COOLANT CIRCUIT
- Refer to CONNECTING THE COOLANT HOSE TO THE RADIATOR
- Refer to INSTALLING THE SUPPORT FOR THE UNDERBODY PROTECTION
- Refer to INSTALLING UNDERBODY PROTECTION AT REAR
- Refer to INSTALLING THE FRONT UNDERBODY PROTECTION
- Refer to INSTALLING THE PROTECTIVE PLATE FOR THE FUEL LINES
- Refer to CONNECTING THE BATTERY EARTH LEAD
- Install right luggage compartment trim panel. Refer to INSTALLING RIGHT LUGGAGE COMPARTMENT WHEEL ARCH PANEL (4' SERIES COUPE/CONVERTIBLE) or INSTALLING RIGHT LUGGAGE COMPARTMENT WHEEL ARCH PANEL (4' SERIES GRAN COUPE SEDAN) .
- Refer to FILLING THE HIGH-TEMPERATURE COOLING SYSTEM WITH THE VACUUM FILLER DEVICE
- Refer to FILLING THE LOW-TEMPERATURE COOLANT CIRCUIT WITH THE VACUUM FILLER DEVICE
- Refer to BLEEDING THE HIGH-TEMPERATURE COOLANT CIRCUIT
- Refer to BLEEDING THE LOW-TEMPERATURE COOLING CIRCUIT
- Refer to CHECKING TRANSMISSION OIL LEVEL/ADDING TRANSMISSION OIL (GA8HP45Z, GA8HP50Z, GA8HP70Z, GA8HP75Z, GAHP90Z) .