Removing and installing or replacing cover on door handle, front left or right (4' Series Coupe/Convertible, 4' Series Gran Coupe Sedan)
Special tools required:
- 64 1 020
When working on trim panel components, make sure that visible surfaces are not scratched or damaged (e.g. by sharp-edged tools).
Unclip cover (1) starting from below using special tool 64 1 020 from clamps (2) and latch mechanisms.
Feed out cover (1) from retaining hook (3).
Installation note:
Install the cover (1) as follows:
- Feed in top retaining hook (3)
- Position on clamps (2) and side latch mechanisms
- Feed in bottom retaining hooks (3)
- Clip in to door trim panel
Installation note:
Retaining hooks (1) and latches on cover (2) must not be missing or damaged.
Installation note:
Clamp (1) may bend up when dismantling the cover.
Bend clamp (1) back by approx. 45° if necessary.
Replace faulty clamps.
Make sure installation location of clamps (2 and 3) is correct.
- Clamps (2) silver
- Clamps (3) black
To replace clamps, disassemble (1) DOOR HANDLE .