Removing and installing/replacing center console cover (4' Series Coupe/Convertible, 4' Series Gran Coupe Sedan)
Special tools required:
- 00 9 325
When working on trim panel components, make sure that the sensitive surfaces are not scratched or damaged.
Necessary preliminary tasks:
- Remove DECORATIVE TRIM ON CENTER CONSOLE .
- Remove CENTER CONSOLE OPERATING UNIT .
Release screws (1).
Release cover (2) with special tool 00 9 325 from clamps (3).
Slightly raise the cover (2) and disconnect associated plug connection.
Feed out cover (2) to the top/rear.
Installation note:
Ensure correct cable routing.
Installation note:
When installing make sure springs (1) are not disengaged.
Replace faulty clamps.
Replacement:
- Modify charging socket (2)
- Modify INTERIOR AERIAL (3)