Removing and installing/replacing left or right deformation element for front bumper panel (4' Series Coupe/Convertible, 4' Series Gran Coupe Sedan)

Necessary preliminary work: 

• REMOVE  support for front bumper panel
• Remove the SUPPORT FOR THE FRONT BOTTOM BUMPER PANEL .
• Remove INTAKE SILENCER HOUSING .

F33 only: 

• Remove front-end strut

Release screws (1).

Tightening torque 51 23 1AZ .

Unfasten screws (2).

Tightening torque 51 11 14AZ .

Lay the engine compartment lock (3) on the top.

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connection and cable clip from fanfare if necessary.

Release screw (1).

Tightening torque 51 11 7AZ .

Loosen screws (3).

Tightening torque 51 11 3AZ .

Release screw (4).

Tightening torque 51 11 6AZ .

Detach deformation element (2) from air duct in area (A) and feed out.

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement: 

Release screws (1) on both sides and remove bracket (2).

Tightening torque 51 11 2AZ .

Release screws (3) and remove lower deformation element.

Tightening torque 51 11 5AZ .

When replacing lower deformation element: 

Release blind rivet from damper (4).

Courtesy of BMW OF NORTH AMERICA, INC.