Removing and installing/replacing both base plates (4' Series Convertible)

Special tools required: 

• 2 288 010

Necessary preliminary tasks: 

• Remove COWL PANEL COVER .

Measure distance (A) from the roller (1) to the base plate (2).

• Version prior to 04/2014 - A = 0.3 mm
• Version as of 04/2014 - A = 1.7 mm

When replacing, both base plates must be installed with a version as of 04/2014.

Replace both base plates (2) if necessary.

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect and unclip cables (1).

Release screws (2) and remove base plate.

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note: 

Insert base plate (1) and thread on screws (2).

Install special tool 2 288 010.

Groove (3) on special tool must not be visible.

Tighten down screws (2).

Tightening torque 54 37 23AZ .

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement: 

Release screws (1).

Tightening torque 54 37 26AZ .

Remount microswitch (2).

Courtesy of BMW OF NORTH AMERICA, INC.

After remounting, the window glass setting will need to be checked and corrected where necessary. Refer to ADJUSTING REAR LEFT OR RIGHT SIDE WINDOW (4' SERIES CONVERTIBLE)

Courtesy of BMW OF NORTH AMERICA, INC.