Installing the tension strut (on the rear axle) on the left or right
NOTE:
TECHNICAL INFORMATION
Driving without the strut brace/front-end strut or tension strut is not permitted.
Driving without the strut brace/front-end strut or tension strut is not permitted.
NOTE:
The description is for one component only. The procedure is identical for all further components.
- Position tension strut (3) .
- Replace screws.
Parts: Bolts
- Tighten down screws (2)
.TIGHTENING TORQUE SPECIFICATIONS
Rear trailing link M12x35
Replace screws.Jointing torque
Angle of rotation100 Nm
90° - Replace screw.
Parts: Screw
- Tighten down screw (1) .
TIGHTENING TORQUE SPECIFICATIONS
| Rear trailing link | |
| M10x20 Replace screw. |
56 Nm |