Remove front entrance cover strip
NOTE:
Description is for left component only. Procedure on the right side is identical.
NOTE:
RISK OF DAMAGE
Bending of plastic components .
Application of too much force can lead to bending of plastic components .
Bending of plastic components .
Application of too much force can lead to bending of plastic components .
- Place special tool directly beside the mounting clip.
- Continue unclipping the part without using the tool if possible.
- Unclip the front door sill cover strip (1) at the clips (2) using the special tool 0 496 569 (00 9 325) in the direction of arrow starting from the rear.
- If applicable, unclip the clips (1) from the floor panel (2).