Removing and installing LED module of left turn indicator (4' Series Coupe/Convertible, 4' Series Gran Coupe Sedan)

Necessary preliminary work: 

• Partially release the FRONT WHEEL ARCH COVER (FRONT SECTION) .

Removal: 

Release screws (1).

Feed out the LED module of the turn indicator (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock and disconnect connector (2).

Remove turn indicator LED module (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

The seal (1) on the LED module of the turn indicator (2) must not be damaged or missing.

Courtesy of BMW OF NORTH AMERICA, INC.

Connect and lock the connector (1) on the LED module of the turn indicator (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Position turn indicator LED module (2) in the headlights.

Tighten down screws (1).

Tightening torque 1.65 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Necessary preliminary work: 

• Install FRONT WHEEL ARCH COVER (FRONT SECTION) .
• Carry out PROGRAMMING/ENCODING .