Removing and installing/replacing a front left (outside) ultrasonic transducer (Park Distance Control) (4' Series Coupe/Convertible, 4' Series Gran Coupe Sedan)
Necessary preliminary tasks:
- Remove FRONT BUMPER TRIM .
Disconnect plug connection.
Unlock retaining tabs (1) in direction of arrow and pull ultrasound transducer (2) upward out of bracket (3).
Installation note:
Before installation of ultrasonic sensor (2) on wiring harness, clean plug connection!
Retaining hooks (1) of ultrasonic transducer (2) must engage exactly in mountings (3).
Installation note:
Make sure rubber ring (1) is correctly seated on ultrasonic sensor (2).