Removing and installing right engine bulkhead
WARNING: This page is about a different car, the 2018 BMW 340i, 2017 BMW 340i, and 2016 BMW 340i. However, it is still accessible from the selected car via links, so may be relevant.
Removal:
Loosen screws (1).
 Courtesy of BMW OF NORTH AMERICA, INC.
|
Loosen the nuts (1).
Remove engine bulkhead (2).
 Courtesy of BMW OF NORTH AMERICA, INC.
|
Installation:
Position engine bulkhead (2).
Tighten the nuts (1).
Tightening torque: 2.6 Nm.
Courtesy of BMW OF NORTH AMERICA, INC.
|
Tighten the screws (1).
Tightening torque: 19 Nm.
Courtesy of BMW OF NORTH AMERICA, INC.
|