REP-TAT-P-1136-02 Installing both actuators

WARNING: This page is about a different car, the 2018 BMW 340i, 2017 BMW 340i, and 2016 BMW 340i. However, it is still accessible from the selected car via links, so may be relevant.

Check seal (1) for damage and, if necessary, replace actuator (2).

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: The figure shows the rear of the engine.

Position both actuators.
Connect and lock both connectors (1).
Make sure the connectors (1) engage audibly.

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: The figure shows the rear of the engine.

Position special tool 2 360 895 correctly on the actuator (1) of the exhaust side.

Courtesy of BMW OF NORTH AMERICA, INC.

Position the actuator (1) of the exhaust side and turn in the arrow direction with the special tool 2 360 895 until the limit stops tap the clamps.

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: The figure shows the rear of the engine.

Position special tool 2 360 895 correctly on the actuator (1) of the intake side.

Courtesy of BMW OF NORTH AMERICA, INC.

Position the actuator (1) of the intake side and turn in the arrow direction with the special tool 2 360 895 until the limit stops tap the clamps.

Courtesy of BMW OF NORTH AMERICA, INC.