REP-TAT-P-1133-25 Replacing all hydraulic valve clearance compensating elements
WARNING: This page is about a different car, the 2018 BMW 340i, 2017 BMW 340i, and 2016 BMW 340i. However, it is still accessible from the selected car via links, so may be relevant.
Removing all hydraulic valve clearance compensating elements
- Remove all hydraulic valve clearance compensating elements (1) to the top.
- Lay the hydraulic valve clearance compensating elements, together with the rocker arms, orderly in the special tool 0 495 105 (11 4 480) .
Installing all hydraulic valve clearance compensating elements
NOTE:
TECHNICAL INFORMATION
If the hydraulic valve clearance compensating elements are reused, they must be reinstalled at the same position.
If the hydraulic valve clearance compensating elements are reused, they must be reinstalled at the same position.
- Install all hydraulic valve clearance compensating elements (1).