REP-TAT-P-1131-25 When replacing intake camshaft: Remount camshaft sensor wheel

WARNING: This page is about a different car, the 2018 BMW 340i, 2017 BMW 340i, and 2016 BMW 340i. However, it is still accessible from the selected car via links, so may be relevant.

Rotate intake camshaft, if necessary in the position shown up to the recess (2).
Loosen screw (1).

Courtesy of BMW OF NORTH AMERICA, INC.
Guide out and remove the camshaft sensor wheel (1).

Courtesy of BMW OF NORTH AMERICA, INC.
Guide the camshaft sensor wheel (1) into the new intake camshaft.

Courtesy of BMW OF NORTH AMERICA, INC.
Rotate intake camshaft, if necessary in the position shown.

NOTE: The recess (2) must point up.

Position camshaft sensor wheel and tighten the screws (1).

TIGHTENING TORQUES SPECIFICATION

Camshaft sensor wheel to intake camshaft
M4 x35	4.5 Nm

Courtesy of BMW OF NORTH AMERICA, INC.