REP-TAT-P-1123-01 Removing the vibration damper
WARNING: This page is about a different car, the 2018 BMW 340i, 2017 BMW 340i, and 2016 BMW 340i. However, it is still accessible from the selected car via links, so may be relevant.
- Position special tool 0 496 595 (11 6 130) and fasten with screw (1).
- Slide counter support on screw (2) in direction of flywheel and turn the engine on the vibration damper until the gearing (3) can reach into the flywheel.
Tighten down screw (2).
- Release screws (1) and remove the vibration damper (2) from the top.