REP-TAT-P-1114-02 Install front engine encapsulation

WARNING: This page is about a different car, the 2018 BMW 340i, 2017 BMW 340i, and 2016 BMW 340i. However, it is still accessible from the selected car via links, so may be relevant.

Install the engine encapsulation (1).

Courtesy of BMW OF NORTH AMERICA, INC.
Correctly route the wiring harness (3) and clip it in at the highlighted areas.
If necessary, position the ground cable and secure it with the screw.

TIGHTENING TORQUES SPECIFICATION

Front ground cable to cylinder head
M6	tightening torque	8 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Connect connectors (1) and (2).

NOTE: TECHNICAL INFORMATION
Make sure that the connections are locked correctly. The locks must engage audibly.

Connect the ventilation line (2) with the intake plenum.
Connect the ventilation line (1) with the tank vent valve and clip it in at the highlighted area.

Courtesy of BMW OF NORTH AMERICA, INC.