REP-TAT-P-1113-25 Replacing oil sump: remount the oil-level sensor
WARNING: This page is about a different car, the 2018 BMW 340i, 2017 BMW 340i, and 2016 BMW 340i. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
RISK OF DAMAGE
Electrostatic discharge.
Damage to or destruction of electrical components.
Electrostatic discharge.
Damage to or destruction of electrical components.
- Leave electrical components in original packaging until just before they are installed. Use the original packaging only for any return shipments. Always package removed components straight away.
- Read and comply with user information on using the associated special tool 12 7 060.
- Only tap the housings of electrical components. Do not tap pins or multi-pin connectors directly.
- Wear electrically conductive clothing and antistatic shoes (with ESD symbol).
- For additional information see: NOTES ON ESD PROTECTION (ELECTROSTATIC DISCHARGE)
- Loosen nuts (2).
- Remove the oil-level sensor (3).
- Install the oil-level sensor (3).
- Tighten nuts (2).
TIGHTENING TORQUES SPECIFICATION
| Oil-level sensor to oil sump | ||
|---|---|---|
| M6 | Joining torque | 2 Nm |
| tightening torque | 8.5 Nm | |