REP-TAT-P-1165-01 Removing the exhaust turbocharger (cylinder head removed)
WARNING: This page is about a different car, the 2018 BMW 340i, 2017 BMW 340i, and 2016 BMW 340i. However, it is still accessible from the selected car via links, so may be relevant.
- Install the special tool 2 446 919 on the exhaust turbocharger and secure it with the bolt (1).
- Make sure that the special tool 2 446 919
is flush with the exhaust turbocharger in the marked area.
- Secure the special tool 2 446 919 by turning the clamping lever (1) in the direction of the arrow.
NOTE:
The clamping lever shown in the graphic is already in its end position.
- Position the holder (1) and fasten it with the bolt (2).
NOTE:
Bracket 1 is used for the final mounting of the special tool 2 446 919.
- Position the retainer (1) and secure it with the nuts (2).
TIGHTENING TORQUES SPECIFICATION
| U bolt to special tool 2 919 (446) | |
|---|---|
| The tightening torque must be observed! Risk of damage to the exhaust manifold! | 1 Nm |
- Position the retainer (1) and secure it with the nuts (2).
TIGHTENING TORQUES SPECIFICATION
| U bolt to special tool 2 919 (446) | |
|---|---|
| The tightening torque must be observed! Risk of damage to the exhaust manifold! | 1 Nm |
- Release nuts in the order (7) till (1) in semicircular pattern.
- Secure exhaust turbocharger against falling down.
NOTE:
TECHNICAL INFORMATION
Do not damage the thermal compensating elements. Disassembly and installation including intermediate storage of the exhaust turbocharger is only permitted with mounted special tool 2 466 919.
Do not damage the thermal compensating elements. Disassembly and installation including intermediate storage of the exhaust turbocharger is only permitted with mounted special tool 2 466 919.
- Remove the sliding rail (1).
- Remove the exhaust turbocharger/exhaust manifold.