REP-TAT-P-1112-02 Installing cylinder head cover
WARNING: This page is about a different car, the 2018 BMW 340i, 2017 BMW 340i, and 2016 BMW 340i. However, it is still accessible from the selected car via links, so may be relevant.
- Replace gaskets (1) and (2).
Parts : Seals
- Make sure that the cylinder head cover (1) is correctly installed in the marked area on the high pressure pump bracket (2).
The cylinder head cover (1) must not tap the high pressure pump bracket (2) in the marked area.
- Position cylinder head cover.
- Make sure that the cylinder head cover does not tap the high pressure pump bracket!
- Tighten all screws in a sequence from (1) to (21).
TIGHTENING TORQUES SPECIFICATION
| Cylinder head cover to cylinder head | |
|---|---|
| M6 x 27 | 10 Nm |
- Clip in wiring harnesses (2) and (3) in the marked regions.
- Connect connector (1).
- Clip in wiring harness (2) in marked areas.
- Connect connector (1).
- Position the holder of the positive battery cable and tighten with the screw (5).
TIGHTENING TORQUES SPECIFICATION
| Holder, positive battery cable to cylinder head cover | |
|---|---|
| Self-tapping plastic screw 6 x 18 | 6.5 Nm |
- Clip in wiring harness (4) in marked areas.
- Clip in the wiring harness (3) in the marked area.
- Correctly route the fuel supply line (2) and tighten with the screw (1).
TIGHTENING TORQUES SPECIFICATION
| Fuel delivery line to cylinder head cover | |
|---|---|
| Self-tapping plastic screw 6 x 18 | 6.5 Nm |
- Connect connector (1) and attach to the wiring harness (2).
NOTE:
TECHNICAL INFORMATION
Detents, guides and mounting elements must not be damaged or missing.
Detents, guides and mounting elements must not be damaged or missing.
- Clip the engine ventilation line (1) in.