33 55 021 Replacing both rubber mounts for anti-roll bar mounting
WARNING: This page is about a different car, the 2018 BMW 330i and 2017 BMW 330i. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Lower the REAR AXLE SUPPORT .
Release screws (1).
Tightening torque, refer to: 33 55 1AZ
Remove retaining brackets (2).
Slide rubber mount (3) towards vehicle exterior and remove.
Installation note:
Keep retaining bracket (2), rubber mount (3) and anti-roll bar clean and free from oil and grease.
Clean anti-roll bar on both sides.
Slide rubber mount with retaining bracket on anti-roll bar to installation position.