33 32 125 Replacing a ball joint in lower steering stub/wheel carrier

Special tools required: 

• 33 3 010
• 2 240 473
• 2 240 469
• 2 240 476

The ball joint may not be reused after it has been pressed out!

Necessary preliminary tasks: 

• Remove the REAR WHEEL .
• Remove the CAMBER ARM COVER .
• Remove the COIL SPRING, REAR .
• Remove the TRAILING ARM .
• Remove the CAMBER ARM .
• If applicable, remove the JOINTED ROD FOR RIDE HEIGHT SENSOR FROM THE CAMBER ARM bracket.

Pull out ball joint: 

Pull out ball joint with special tools 33 3 010, 2 240 473 and 2 240 469.

Courtesy of BMW OF NORTH AMERICA, INC.

Pull in new ball joint: 

Fit new ball joint (1) with special tools 33 3 010, 2 240 473, and 2 240 476 until limit position.

Courtesy of BMW OF NORTH AMERICA, INC.

After installation: 

• Carry out WHEEL ALIGNMENT CHECK .