37 14 511 Replacing front ride height sensor
WARNING: This page is about a different car, the 2018 BMW 330i and 2017 BMW 330i. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Read and comply with notes on protection against electrostatic damage, refer to: (ESD PROTECTION)
.
Slacken nut (1).
Tightening torque, refer to: 37 14 4AZ.
Detach jointed rod (2).
Disconnect plug connection (3).
Release screws (4).
Tightening torque, refer to: 37 14 2AZ .
Remove ride height sensor to front.
Installation note:
Replace nut (1).
Sensor lever points in direction of travel starting from ride height sensor.
After installation:
- Check headlight adjustment, correct if necessary.