11 33 050 Removing and installing/replacing all rocker arms (B48B)

WARNING: This page is about a different car, the 2018 BMW 330i and 2017 BMW 330i. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

11 4 480

Necessary preliminary work:

Remove INTAKE CAMSHAFT
Remove EXHAUST CAMSHAFT .

IMPORTANT: Roller cam followers on intake side are subdivided into bearing classes.
Already used roller cam followers may only be reused in the same position.

Removal:

Release roller cam followers (1) on intake side from hydraulic valve clearance compensating elements and remove.

Place all roller cam followers in order in special tool 11 4 480 .

Courtesy of BMW OF NORTH AMERICA, INC.

Release roller cam followers (1) on exhaust side from hydraulic valve clearance compensating elements and remove.

Place all roller cam followers in order in special tool 11 4 480 .

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Classification of roller cam follower intake.

The tolerance classes are marked according to the illustration in numbers from 1 to 5.

Standard: Number 3. standard.

Number 2. slow idle.

Number 4. fast idle.

In case of repair: rough idling speed.

Courtesy of BMW OF NORTH AMERICA, INC.

Repair: 1

Number 1. lower engine speed in idle.

Number 5. higher engine speed in idle.

Install roller cam followers (1) on intake side.

NOTE: Ensure correct position of roller cam followers on hydraulic valve clearance compensating elements and intake valves.

Courtesy of BMW OF NORTH AMERICA, INC.

Install roller cam followers (1) on exhaust side.

NOTE: Ensure correct position of roller cam followers on hydraulic valve clearance compensating elements and exhaust valves.

Courtesy of BMW OF NORTH AMERICA, INC.

Required follow-up work:

Install EXHAUST CAMSHAFT
Install INTAKE CAMSHAFT