13 62 673 Replacing the component temperature sensor on the cylinder head (B48)

WARNING: This page is about a different car, the 2018 BMW 330i and 2017 BMW 330i. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Risk of scalding!
Only perform this repair work on an engine that has cooled down.

Necessary preliminary tasks:

Remove the ACOUSTIC COVER
Remove the DESIGN COVER .

Removal:

Release cable clip (1).

Thread out wiring harness (2) and place to side.

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock and disconnect plugs (1).

Loosen component temperature sensor (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Tighten component temperature sensor (2).

Tightening torque, refer to: 13 62 8AZ .

Attach and lock connector (1).

Connector (1) must engage audibly.

Courtesy of BMW OF NORTH AMERICA, INC.

Feed in and install wiring harness (2).

Secure cable clip (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Required follow-up work:

Install the ACOUSTIC COVER .
Install the DESIGN COVER .