13 62 592 Replacing charging pressure sensor (on intake plenum) (B48)

WARNING: This page is about a different car, the 2018 BMW 330i and 2017 BMW 330i. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove the ACOUSTIC COVER

Removal:

Unlock and disconnect plugs (1).

Release screw (2).

Release charging pressure sensor (3) along arrows and remove.

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Install charging pressure sensor (3) and lock along the arrows.

Charging pressure sensor (3) must latch audibly into locks.

Tighten screw (2).

Tightening torque, refer to: 13 62 6AZ .

Attach and lock connector (1).

Connector (1) must engage audibly.

Courtesy of BMW OF NORTH AMERICA, INC.

Required follow-up work:

Install the ACOUSTIC COVER .