13 62 560 Removing and installing/replacing hot film air mass meter (B48)

WARNING: This page is about a different car, the 2018 BMW 330i and 2017 BMW 330i. However, it is still accessible from the selected car via links, so may be relevant.

Removal:

Unlock and disconnect plugs (1).

Loosen screws (2).

Feed out and remove the hot film air mass meter (3).

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Guide in and install hot film air mass meter (3).

Tighten down screws (2).

Tightening torque, refer to: 13 62 7AZ .

Attach and lock connector (1).

Connector (1) must engage audibly.

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement only:

Reset the adaptation settings for the mass air flow system using the BMW diagnosis system.