13 62 538 Removing and installing/replacing the charging pressure sensor on the charge air line (B48)

Necessary preliminary tasks: 

• Remove the DESIGN COVER .
• Remove the ACOUSTIC COVER

Removal: 

Unlock and disconnect plugs (1).

Release screw (2).

Remove the charging pressure sensor (3).

Courtesy of BMW OF NORTH AMERICA, INC.

Preparation for installation: 

Replace sealing rings (1) if damaged.

Part:  Sealing ring

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Insert and install the charging pressure sensor (3).

Tighten screw (2).

Tightening torque, refer to: 13 62 3AZ .

Attach and lock connector (1).

Connector (1) must engage audibly.

Courtesy of BMW OF NORTH AMERICA, INC.

Required follow-up work: 

• Install the DESIGN COVER .
• Install the ACOUSTIC COVER .