13 62 532 Replace the coolant temperature sensor on the crankcase (B48)

WARNING: This page is about a different car, the 2018 BMW 330i and 2017 BMW 330i. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Risk of scalding!
Only perform this repair work on an engine that has cooled down.

Recycling

Catch and dispose of escaping coolant.

Observe country-specific waste disposal regulations.

Necessary preliminary tasks:

Remove the INTAKE PLENUM .

Removal:

Unlock and disconnect plugs (1).

Release and remove coolant temperature sensor (2).

Collect and dispose of escaping coolant.

Replace gasket.

Part: Gasket.

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Screw in and tighten coolant temperature sensor (2).

Tightening torque, refer to: 13 62 9AZ .

Attach and lock connector (1).

Connector (1) must engage audibly.

Courtesy of BMW OF NORTH AMERICA, INC.

Required follow-up work:

Install the INTAKE PLENUM .
Check coolant level, top up if necessary
Check cooling system for leaks.