34 11 Front Brake F30
WARNING: This page is about a different car, the 2018 BMW 330i xDrive, 2018 BMW 330i, 2017 BMW 330i xDrive, and 2017 BMW 330i. However, it is still accessible from the selected car via links, so may be relevant.
34 11 FRONT BRAKE F30 - TECHNICAL DATA SPECIFICATIONS
| Attention! Installation of new brake pads is approved only provided that the brake disc thickness exceeds the specified dimension for "MIN TH" (see table). Brake discs must be replaced when they reach the nominal thickness (see table) minus 2.4 mm! (Not applicable to perforated brake discs and M vehicles) Applies only to M vehicles and perforated ventilated brake discs: The brake discs must be replaced once they wear to the nominal specified thickness (see table) minus 1.6 mm! Depending on:
different brake discs can be fitted The brake discs must always be assigned by way of the relevant vehicle identification number and the applicable BMW Parts Catalogue! |
||
| Different thicknesses on brake linings | Max. mm | 0.01 |
| (MIN TH) is stamped in brake disc chamber | mm | 22.4 |
| Nominal size (diameter x thickness) | mm | 330x24 |
| (MIN TH) is stamped in brake disc chamber | mm | 22.4 |
| Nominal size (diameter x thickness) | mm | 312x24 |
| (MIN TH) is stamped in brake disc chamber | mm | 20.4 |
| Nominal size (diameter x thickness) | mm | 300x22 |
| (MIN TH) is stamped in brake disc chamber | mm | 28.4 |
| Nominal size (diameter x thickness) | mm | 340x30 |
| (MIN TH) is stamped in brake disc chamber | mm | 28.4 |
| Nominal size (diameter x thickness) | mm | 370x30 |
| Wear warning from residual lining thickness | mm | 3.7 |