REP-TAT-P-3221-26-F30 Remounting the track rod end
WARNING: This page is about a different car, the 2018 BMW 330i and 2017 BMW 330i. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
TECHNICAL INFORMATION:
Perform wheel alignment after installation.
Perform wheel alignment after installation.
NOTE:
Description is for left component only. Procedure on the right side is identical.
- Determine dimension (A) to simplify subsequent setting of front axle.
- Slacken screw (1).
- Unscrew the track rod end, if applicable, counter support the track rod with the open-end spanner.
- Screw on the track rod end to this dimension (A).
- Tighten down screw (1).
TIGHTENING TORQUES SPECIFICATION
| Track rod end to track rod | 32Nm |